JYMAG - Manual commands' window

This window allows you to send your own commands to the phone. This can be helpful if you want to check what a given command does or if you want to use a command that isn't supported by JYMAG.

This window can also serve as a general-purpose serial port terminal allowing you to send commands to any device, not just supported phones.

The port and its settings are the ones set in the main window.

1. Type your command in the top text area.
2. Press "Send" to send the command to the device. While waiting for the answer, the command area and the "Send" button are disabled.
3. The sent commands appear in the middle text area.
4. The device's replies appear in the bottom area.
5. Press "Exit" to close the window.
6. Press "Clear" to clear the reply area.
7. Use the font size spinner to adjust the font size of this window.
8. Use the "Send file" button to send a file to the device as commands.
9. Use the "RTS" and "DTR" push-buttons to control the state of the port's control signal lines.
10. The circles show the current state of the given control signal line (green - enabled, grey - disabled).