JYMAG - Main window

This is the main window of the JYMAG program. It allows you to perform many different operations. Use the font size spinner at the top of the window to adjust the font size of this window and all windows opened from this window.

On the top left side of the window you can set the communication port's parameters:

1. The Port list allows you to select which communication port to use. If you don't know which port to use, press the "Scan ports" button. When scanning is finished, the port that replied is automatically selected or you're presented with a list to choose from. In any case, you can always select another port. Choosing different ports allows you to see which port have replied with what information - this information is shown using the four labels in the middle section of the window.

   If your port is not on the list, check if:

   • the phone connects with a serial link (not as a USB mass storage device, for example)
   • you have installed a correct driver for the cable/IrDA/other devices
   • the phone's port is not already in use
   • you have the newest RxTx
   
   
2. The Speed list allows you to choose the transmission speed. Set this to the value set in the phone (or other device you're connecting to) or leave the default 115200.
   
   
3. Choose the number of data bits to use: 8 (the recommended default), 7, 6 or 5.
   
   
4. Choose the parity checking: None (the recommended default), Even, Odd, Space, Mark.
   
   
5. Choose the number of stop bits: 1 (the recommended default), 1.5 or 2.
   
   
6. Choose the flow control mode: None (both checkboxes deselected - the recommended default), Software or Hardware.
   
   

1. "Load configuration" allows you to load your settings from a previously-saved JYMAG configuration file.
   
   
2. "Save configuration" allows you to save your settings to a file. The following settings are saved:
   • port name
   • port speed setting
   • port data bits setting
   • port parity setting
   • port stop bits setting
   • port flow control setting
   • main window's position
   • main window's size and whether is was maximized or not
   • main window's font size
   • main window's selected tab
   
   

1. The phone type label - contains the phone type returned by the phone (if any) after you have pressed "Scan ports".
   
   
2. The phone's firmware version returned by the phone (if any) after you have pressed "Scan ports".
   
   
3. The phone's IMEI number returned by the phone (if any) after you have pressed "Scan ports".
   
   
4. The subscriber number of the currently-inserted SIM card returned by the phone (if any) after you have pressed "Scan ports". This is simply your phone number.
   
   
5. The program status label tells if the program is ready for your command, receiving or sending data.
   
   
6. The progress bar shows the progress of the current operation.
   
   

• pictures/photographs
• ringtones/melodies/music files
• addressbook (phonebook) entries
• to-do tasks
• events/tasks
• animation/videos/movies
• Java elements
• alarm clock entries
• SMS messages
• dialing numbers

More information can be found on the tabs' page.

1. "Scan ports" - press this to scan the found serial ports for replies. When scanning is finished, the port that replied is automatically selected or you're presented with a list to choose from. In any case, you can always select another port. Choosing different ports allows you to see which port have replied with what information - this information is shown using the four labels in the middle section of the window.
   
   
2. "About JYMAG" - opens the about window.
   
   
3. "Manual commands" - opens the manual commands' window.
   
   
4. "Get capabilities" - opens the capabilities' window.
   
   
5. "Signal power" - opens the signal power display window.
   
   
6. "Exit" - closes JYMAG.